Product Home Drawings

EZ-EYE™

Miniature Push-Button Photoelectric Sensor

Product subject to change without notice.
 

SUPPLY VOLTAGE
  • 10 to 24 VDC
  • Polarity Protected
CURRENT REQUIREMENTS
  • 50 mA (exclusive of load)
OUTPUT TRANSISTORS
  • (1) NPN and (1) PNP sensor output transistor
  • Sensor’s output can sink or source up to 150 mA (current limited)
  • Outputs are continuously short-circuit protected
RESPONSE TIME
  • Light State response = 500 microseconds
  • Dark State response = 500 microseconds
LED LIGHT SOURCE
  • Red = 660 nm
  • Infrared = 880 nm
  • Pulse Modulated
PUSH BUTTON CONTROL
  • AUTOSET™ Routine: Push and release with sensor in “light” state
  • Excess Gain Adjustment: Tap twice to step to higher excess gain
  • Push and hold to activate Flash Rate Alignment Indicator
  • Light /Dark “ON” selection: Tap 5 times to toggle
 RANGE
  • Dependent on optical block (see range guidelines)
HYSTERESIS
  • Approximately 15% of signal
LIGHT IMMUNITY
  • Responds to sensor’s pulse-modulated light source, resulting in high immunity to most ambient light, including high intensity strobes.
DIAGNOSTIC INDICATORS
  • Dual Red/Green LED:
    Red = Output Status
    Green = Flash Rate Alignment Indicator
  • Dual Green/Amber LED:
    Green = “ON” After AUTOSET™ Routine
    Amber = “ON” After Excess Gain Adjustment
     
AMBIENT TEMPERATURE
  • -40° to 70°C (-40° to 158° F)
RUGGED CONSTRUCTION
  • Chemical resistant, high impact polycarbonate housing
  • Waterproof ratings: NEMA 4, IP67
  • Conforms to heavy industry grade CE requirements