X-tremely High Speed Registration Sensor
Product subject to change without notice.
SUPPLY VOLTAGE: • 10 to 30 VDC • Polarity Protected • Intended for use in Class 2 circuits
CURRENT REQUIREMENTS: • 30 milliamps (exclusive of load)
OUTPUT TRANSISTORS: • (1) NPN and (1) PNP sensor output transistors • Outputs sink or source up to 150 milliamps (current limit) • All outputs are continuously short circuit protected
REMOTE AUTOSET INPUT: • XM/XMC-1 & 2 Models – Momentary sinking input (1mA) • XM/XMC-3 Models – Momentary sourcing input (1mA) Note: Remote programming available in XM/XMC-1 Models only.
REMOTE LT/DK INPUT • XM/XMC-2 Model – Connect to Negative/0VDC • XM/XMC-3 Model – Connect to Positive/10-30VDC
RESPONSE TIME • 10µs
REPEATABILITY • 5µs
LED LIGHT SOURCE: • White = Broadband Color Spectrum
PUSH BUTTON CONTROL: • AUTOSET • INVERT outputs • Manual Adjustments • Timer – 10ms Pulse Stretcher
AMBIENT TEMPERATURE: •10ºC to 60ºC (50ºF to 140ºF)
DIAGNOSTIC INDICATORS • Contrast Indicator – Display scaled reading of sensor’s response to contrasting light levels (light vs. dark) on an 8 bar LED display Note: All 8 LEDs will flash three times if contrast insufficient or too low in Two-Point AUTOSET mode. • Red LED Output Indicator – Illuminates when the sensor’s output transistors are “ON” Note: If Output LED flashes, a short circuit condition exists. • Green LED Timer Indicator – Illuminates when the 10ms pulse stretch timer is enabled • Red LED INVERT Indicator – Illuminates when INVERT is enabled
LIGHT IMMUNITY • Responds to sensor’s pulsed modulated light source – immune to most ambient light including indirect sunlight
RUGGED CONSTRUCTION: •Chemical resistant high impact polycarbonate housing •Waterproof, ratings: NEMA 4x, 6p and IP67 enclosure rating •Conforms to heavy industry grade CE requirements
HYSTERESIS • Dynamic – adjusted by AUTOSET