SUPPLY VOLTAGE:
• 10 to 30 VDC
• Polarity Protected
• Intended for use in Class 2 circuits

CURRENT REQUIREMENTS:
• 30 milliamps (exclusive of load)

OUTPUT TRANSISTORS:
• (1) NPN and (1) PNP sensor output transistors
• Outputs sink or source up to 150 milliamps (current limit)
• All outputs are continuously short circuit protected

REMOTE AUTO-SET INPUT:
• XM/XMC-1 & 2 Models – Momentary sinking input (1mA)
• XM/XMC-3 Models – Momentary sourcing input (1mA)
Note: Remote programming available in XM/XMC-1 Models only.

REMOTE LT/DK INPUT
• XM/XMC-2 Model – Connect to Negative/0VDC
• XM/XMC-3 Model – Connect to Positive/10-30VDC

RESPONSE TIME
• 10µs

REPEATABILITY
• 5µs

LED LIGHT SOURCE:
• White = Broadband Color Spectrum

PUSH BUTTON CONTROL:
• AUTOSET
• INVERT outputs
• Manual Adjustments
• Timer – 10ms Pulse Stretcher

AMBIENT TEMPERATURE:
•10C to 60C (50F to 140F)

DIAGNOSTIC INDICATORS
• Contrast Indicator – Display scaled reading of sensor’s response to contrasting light levels (light vs. dark) on an 8 bar LED display
Note: All 8 LEDs will flash three times if contrast insufficient or too low in Two-Point AUTOSET mode.
• Red LED Output Indicator – Illuminates when the sensor’s output transistors are “ON”
Note: If Output LED flashes, a short circuit condition exists.
• Green LED Timer Indicator – Illuminates when the 10ms pulse stretch timer is enabled
• Red LED INVERT Indicator – Illuminates when INVERT is enabled

LIGHT IMMUNITY
• Responds to sensor’s pulsed modulated light source – immune to most ambient light including indirect sunlight

RUGGED CONSTRUCTION:
•Chemical resistant high impact polycarbonate housing
•Waterproof, ratings: NEMA 4x, 6p and IP67 enclosure rating
•Conforms to heavy industry grade CE requirements

HYSTERESIS
• Dynamic – adjusted by AUTOSET